PVC mixer is used for mixing, stirring and coloring of materials in plastics, rubber, daily chemical industry and other industries. It is a special equipment for the production of plastic sheet, pipe, profile and degradation of plastics. It is mainly used for cutting, dispersing, emulsifying and mixing of powdered liquid raw materials with different viscosities. It is stirred and mixed through the high-speed operation of the upper, middle and lower three pieces of the pulp blade to carry out high-speed strong shear, impact, crushing and dispersing of the materials to achieve the functions of rapid mixing, dissolution, dispersion and volatilization.
Material and working principle of PVC mixer:
The material of the pot body is made of 6mm stainless steel plate, the inner surface is extremely smooth and hard, with wear resistance, corrosion resistance, high temperature resistance and not easy to dip material and so on. The lid is made of ZL102 cast aluminum, and the inner surface is polished and polished. It is not easy to stick material, so it is easy to open the lid.
The bottom of the pot is made of 8mm stainless steel, the material of the stirring paddle is made of stainless steel, the surface is polished, the surface is smooth and hard, wear resistant, corrosion resistant. Hot mix by pneumatic open pot cover, the main shaft adopts 3 sets of deep groove ball bearings the main shaft seal adopts a variety of sizes of skeleton double lip oil seal seal, dump plate, gas seal and other sealing methods, can prevent materials from entering the shaft seal parts, sealing reliable and stable. Using belt deceleration mode, reliable work, but also can prevent overload.
PVC mixer hot mixing pot cover sealing method adopts two silicone rubber sealing strips, sealing reliable, high temperature resistance, no deformation. Advanced equipment, easy to operate, safe and reliable. Small size, light weight, high efficiency, low energy consumption, low noise, is your ideal choice of products. With a high degree of automation, fast mixing speed, frequency control can be adopted, the paddle for precision stainless steel pressure casting, and through the static and dynamic balance test. In particular, the impeller of the cooling machine uses foreign advanced spiral mixing structure, the whole container has no dead Angle, with fast cooling speed, clean discharge, mixing effect has reached the advanced level of foreign countries. The mixing slurry is driven by the motor through the belt. The motor is an AC two-speed motor. As long as the button of low and high speed is pressed, the low and high speed can be realized. But it must be noted that: to operate at high speed, the motor should be started at low speed, and then the spindle should be carried and turned by the bearing. There are three mixing slurry on the upper part of the main shaft, they rotate clockwise, so that the material on the one hand along the wall of the pan, and at the same time the up and down circulation of turning and the role of the guide plate, so that the mixing effect is better.
Relevant Articles
Why there are no dead corners in high-speed mixers
How can a high-speed mixer speed up the flow rate of materials? To ensure efficient production, whi…
What is the Feeding Sequence of the Mixer?
What is the feeding sequence of the high-speed mixer? When using a high-speed mixer, pay attention …
Structure and Operation of PVC Mixer
During the operation of the PVC mixer, due to the multi-directional operation of the mixing barrel,…